The DYNOTUNE PROGRESSIVE/RPM WINDOW SWITCH is a single stage progressive Nitrous controller, RPM activated window switch (RPMWS) with an integrated throttle-position activation switch (TPAS). The unit accepts most tach signals, including low-voltage and irregular signals such as those found on many V-10s (Some mustangs will require a tach adaptor for the window switch to function properly, its best to try without it first, if you notice that the tach reading jumps around and does not read properly you should get a tach adaptor from companies like MSD or Autometer).

The TPAS accepts all analog throttle-position sensor signals(even fly by wire) as well as a “hot” or “grounded” mechanical wide-open-throttle (WOT) switch.

This unit has settable ON/LOW and OFF/HI RPM points and multi-gear lockout feature.  Multi-gear lockout delays the stage from turning ON until you have cycled through the RPM window (X times). The internal TPAS can be configured to prevent the RPMWS channel from activating until you are at WOT.

The progressive part will pulse up to 2 solenoids. It will pulse the solenoids so the power will come on smooth and clean to reduce wheel spin. Fully programmable via the buttons on the front of the unit. Example, leave the line at 50% power and ramp the power to 100% over 2 seconds. The small package is great for any application, bikes, cars, trucks etc. 

The DYNOTUNE RPM WINDOW SWITCH requires 9~18 volts to operate correctly. The output line switches HOT when activated (ON) and has a maximum current rating of 1 amp. You will need to use the driver/relay that is provided in the kit. Good for switching 60 AMPS.

Checkout all these features:

--Microprocessor contolled

--Built in Progressive pulsing controller 

--Built in TPS (WOT) Switch

--Built in RPM window switch with multi-Gear lockout(traction control)

--Multiple outputs 12V and Ground(use the ground to trigger other devices) 

--Seprate Driver Module for Progressive controller means fast powerful response in controlling the solenoids(up to ( qty 2) 250HP solenoids) 60 AMPS

--Rest/Resume progressive, lets you shift and continue the progressive where it left off.

--6 Foot wire harness

--Light Weight

--12 Volt Operation  

--Super Low Current

--Draw Micro Package Mounts Anywhere 1.8" Wide x 2.4" Tall x .9" Deep
 

NOTE: Not for use with zex nitrous kits with solenoids built into the control box.