Shop Hours
M-F 10-4
Dealers Wanted!
Due to rapid growth and an expanding product line. Contact us for details!
Air/Co2 Shifters
Brackets
Bottles & Parts
Braided Lines
Direct Port Parts
Electrical Parts
Gauges Round
Gauges Square
Gauge Adaptors
Jets
N2O Controllers
Nitrous Fittings
Nitrous kits
Openers
Purge kits
Sensors & Bungs
Solenoids
Warmer kits
Other Parts
Wide Band Gauges
Under Development
1) Air/Fuel ratio lean shutoff switch
New Products
1) DynoTune Digital air shifter kill box.
2) Next Up Fuel or ignition kill box for air/co2 shift kits
3) Low Cost Progressive controller now in stock!
This is a billet LED purge light mounting bracket. It has a 1/8" stainless tube sticking out of the mount so you can attach your LED Purge light to It. Great for bikes or street rods where the solenoid is remote located. Simply use your -4AN braided line or 1/8" high pressure tubing to the nozzle and use the two screws to mount the bracket. The stainless tube can also be bent to point the LED light purge in many diffrent directions. Kit comes with the bracket, Blue 4AN fitting or 1/8" high pressure tubing fitting and the stainless tube. NOTE:DOES NOT INCLUDE BRAIDED LINE, HIGH PRESSURE TUBING OR LED PURGE LIGHT! See the braided line section, make sure you get a line with a -4AN fitting if you use the braided line. See the LED purge light section....This Bracket will fit any LED purge light that has a 1/8" hole in the center (NOS/DynoTune etc)