Advanced Search       

Shopping Cart
Qty 0
Total $0.00
 

 

HomeAbout Our GaugesNitrous Jet CalculatorCustomer PicturesVideo'sInstructionsAccountCartCheckoutContact Us

 

Products

 

 

Air/Co2 Shifters

 

 

 

Brackets

 

 

  Bottles & Parts

Braided Lines

Direct Port Parts

Electrical Parts

Gauges Round

Gauges Square

Gauge Adaptors

Jets

N2O Controllers

Nitrous Fittings

Nitrous kits

Openers

Purge kits

Sensors & Bungs

Solenoids

Warmer kits

 

Other Parts

 

 

 

   Wide Band Gauges

 


Under Development

Under Development

 

 

New Products

1) DynoTune Digital air shifter kill box.

 

 

2)Air/Fuel ratio lean shutoff switch

 

 

3) Low Cost Progressive controller now in stock!

 

 

 

 

 


Your IP Address
For security, your IP address is recorded as:
44.211.34.178


Custom Nitrous Lines-- Made to Order (595.2)

Custom Nitrous Lines-- Made to Order

 

If your not sure what you need please call us first! Rememeber, these lines are custom and cannot be returned for any reason.

Custom Nitrous Lines-- Made to Order. We make and ship your line typically the same day. We use the highest quality line and fittings. Braided stainless with teflon inner tubing.

1) Pick your line length from tip to tip(very end of the an fittings) in .5  inch increments: example Line length 12.5-24 inches - $19.95

2) Enter line length tip to tip: example Enter Line Length Tip to Tip In Inches,  .5 inch steps : 22.5 inches

3) Pick your line size: example -3 Size Line(Typical Goes To Wet Or Dry Nozzles)

3) Pick your fitting on one end of the line: example Blue 3AN (Fogger Nozzle size)

4) Pick your fitting on the other end of the line: example Blue 3AN (Fogger Nozzle size)

You can mix and match fittings and line sizes for serious custom lines. example, put -3 Blue nuts on -4 size line...

 

Refrence info:

-3AN Nuts use a 7/16" wrench

-3AN Lines are about .25" wide

-4AN Nuts use a 9/16" wrench

-4AN Lines are about .30" wide

"AN" means Army Navy...they are flare fittings and require no teflon paste or tape to seal them.

"NPT" means national Pipe thread.... they are tapered and require teflon tape or sealer to seal. Teflon tape seals the best, use 4 wraps around the fitting keeping the tape about one thread from the end.

If your not sure what you need please call us first! Rememeber, these lines are custom and cannot be returned for any reason.



Miscellaneous :
Product Inquiry
    
Ready To Order?

Item in stock!

Custom Line Length (*) :

Enter Line Length Tip to Tip In Inches .5 steps (*) :

Line size (*) :

Fitting #1 (*) :

Fitting #2 (*) :


 



(*) Mandatory Option


Related Products :


| Privacy |
Copyright 2024  DynoTune  
Page displayed in: 0.0781 seconds.